Hello everybody!
I tried to install td_hd_neutrino_20120220 .bz2 on the second partition "sda2" (system partition 1) of HDD.
But the receiver locks itself on startup ...
I followed the steps:
First of all I installed the hdd in the correct way.
1) Go to osd menu-->system setup --> more system setup --> harddisk--> install --> initialise HDD -->now.... for to partinion the HDD;
2) Download td_hd_neutrino_20120220.tar.bz2 (
http://tuxbox.trale.de/ )
3) Clear the /mnt/hd/data directory.(telnet- "rm -rf /mnt/hd/data/*")
4) Upload td_hd_neutrino_20120220.tar.bz2 to /mnt/hd/data
5) Un-tar the archive...
cd /mnt/hd/data
tar -zxvf td_hd_neutrino_20120220.tar.bz2
6) Reboot and go into Bootmenu
7) Change Kernel Commandline to option 3. Save settings and reboot...
When starting up the receiver, based on the help of the PuTTY (--> COM1-->serial-->speed 115200), I receive the following message on the PC :
/ (C) MNC Ltd. Set-Top-Box \
\ BIOS 3.29 (2005/11/07) /
-------------------------------
\ .--. Serialnumber: Tripledragon-EU-0-170327161-S
|o_o | PowerPC at : 252 MHz, EBIU: 63 MHz, PVR: 41810952, VDEV: 0B
|:_/ | RAM config : B0: 2x32=64 MB, B1: 2x8=16 MB, [80 MB]
// \ \ Flash memory: Size: 8 MB, Manufacturer: 04, Type: 22D7
(| | ) Tunertype : DVB-S, Sat-Tuner BS2F7VZ0184
/'\_ _/`\ Ethernet : Chip 33, Revis. 91 (SMC91C11x)
\___)=(___/ Network : not initialised yet
Ethernet MAC: BADDAD26FC79, TD IP: 192.168.1.123, Host IP: 192.168.1.1
F-System: 0xFF9C0000, 0x480000 (4718592 Byte), VAR: 1769472 Byte / 27 sect
Kernel : 0xFFE40000, 0x197A00 (1669632 Byte / 26 sect), autostart
Main Bios-Menu
0 - Boot
R - Reset
S - Save config
B - Boot/Kernel Setup
E - Upgrade/Flash/Network
H - Hardware Setup
L - Loader Config
V - Video/Modulator Setup
->
loaded at: 00500000 00698178
relocated to: 00400000 00598178
board data at: 00596124 00596178
relocated to: 0040515C 004051B0
zimage at: 004058B1 00595D07
avail ram: 00599000 04000000
Linux/PPC load: console=ttyS1,115200 root=/dev/ide/host0/bus0/target0/lun0/part2 rw mtdparts=phys_mapped_flash:64k(conf),1728k(var),4718592(filesystem),1703936(kernel),128k(ppcboot)ro
Uncompressing Linux...
.
Now booting the kernel (misc-embedded)
Linux version 2.6.12 (flow@flownix) (gcc version 3.4.1) #396 Tue Oct 4 23:22:10 CEST 2005
machine: TRIPLEDRAGON STB
bi_s_version (bd_t struct's version) : 1.7
bi_r_version (bios/bootloader version): 3.29
bi_memsize : 0x04000000 (65)MBytes
bi_memsize1: 0x01000000 (16)MBytes
bi_enetaddr: ba:dd:ad:26:fc:79
bi_intfreq (CPU speed) : 0x0f053700 (252)Mhz
bi_busfreq (PLB clock) : 0x03c14dc0 (63)MHz
bi_tbfreq (SW timebase): 0x019bfcc0 (27)MHz
bi_opb_busfreq : 0x03c14dc0 (63)MHz
bi_iic_fast enable : [0] 0, [1] 0
flash_base : 0xff800000
MNC Ltd. DBx3000
http://www.mncltd.com
Built 1 zonelists
Kernel command line: console=ttyS1,115200 root=/dev/ide/host0/bus0/target0/lun0/part2 rw mtdparts=phys_mapped_flash:64k(conf),1728k(var),4718592(filesystem),1703936(kernel),128k(ppcboot)ro
PID hash table entries: 512 (order: 9, 8192 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 61312k available (2724k kernel code, 724k data, 88k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
Squashfs 2.2 (released 2005/07/03) (C) 2002-2005 Phillip Lougher
Squashfs 2.2 includes LZMA decompression support
devfs: 2004-01-31 Richard Gooch (
rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
SGI XFS with no debug enabled
Serial: 8250/16550 driver $Revision: 1.90 $ 3 ports, IRQ sharing disabled
ttyS0 at MMIO 0x0 (irq = 20) is a 16550A
ttyS1 at MMIO 0x0 (irq = 21) is a 16550A
ttyS2 at MMIO 0x0 (irq = 31) is a 16550A
io scheduler noop registered
io scheduler deadline registered
loop: loaded (max 8 devices)
smc91x.c: v1.1, sep 22 2004 by Nicolas Pitre <
nico@cam.org>
eth0: SMC91C11xFD (rev 1) at c5056300 IRQ 28
eth0: Ethernet addr: ba:dd:ad:26:fc:79
eth0: PHY LAN83C183 (LAN91C111 Internal)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
physmap flash device: 800000 at ff800000
phys_mapped_flash: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
phys_mapped_flash: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
5 cmdlinepart partitions found on MTD device phys_mapped_flash
Creating 5 MTD partitions on "phys_mapped_flash":
0x00000000-0x00010000 : "conf"
0x00010000-0x001c0000 : "var"
0x001c0000-0x00640000 : "filesystem"
0x00640000-0x007e0000 : "kernel"
0x007e0000-0x00800000 : "ppcboot"
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.01:USB HID core driver
mice: PS/2 mouse device common for all mice
IBM IIC driver v3.1
ibm-iic0: using standard (100 kHz) mode
ibm-iic1: using standard (100 kHz) mode
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
NET: Registered protocol family 1
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
STB04500 OCP IDE 2.74 - Built Oct 3 2005/12:18:01 for 2.6.12 (none debug)
hda: WDC WD1200JB-00REA0, ATA DISK drive
ide0 at 0xc505c1f8-0xc505c1ff,0xc505c1f6 on irq 25
hda: max request size: 1024KiB
hda: Host Protected Area detected.
current capacity is 234435439 sectors (120030 MB)
native capacity is 234441648 sectors (120034 MB)
hda: Host Protected Area disabled.
hda: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=16383/255/63, UDMA(66)
hda: cache flushes supported
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
Root-NFS: No NFS server available, giving up.
VFS: Unable to mount root fs via NFS, trying floppy.
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda2, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem).
Mounted devfs on /dev
Freeing unused kernel memory: 88k init
init started: BusyBox v1.18.4 (tripledragon)
/etc/init.d/rcS: line 20: ldconfig: not found
starting /etc/init.d/S01mount ...
root FS is mounted rw, skipping filesystem check
starting /etc/init.d/S50hostname ...
starting /etc/init.d/S51networking ...
Configuring network interfaces... eth0: link down
udhcpc (v1.18.4) started
Sending discover...
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
Sending discover...
Sending select for 192.168.1.163...
Lease of 192.168.1.163 obtained, lease time 43200
Starting ifplugd...
.
starting /etc/init.d/S52syslogd ...
Jan 1 01:00:33 tripledragon syslog.info syslogd started: BusyBox v1.18.4
starting /etc/init.d/S54inetd ...
starting /etc/init.d/S55loadmodules ...
STB04500 TDCORE 2.07 - Built Oct 28 2005/14:57:11 for 2.6.12 (none debug)
tdav: no version for "os_call_irq_task" found: kernel tainted.
STB04500 TDAV 1.48 - Built Nov 16 2005/19:31:49 for 2.6.12 (none debug)
STB04500 TDPANEL 1.20 - Built Oct 28 2005/14:57:25 for 2.6.12 (none debug)
STB04500 TDTUNER 2.14 - Built Oct 28 2005/14:57:40 for 2.6.12 (none debug)
STB04500 TDCA 1.18 - Built Oct 28 2005/14:57:27 for 2.6.12 (none debug)
STB04500 TDCI 1.42 - Built Oct 28 2005/14:57:31 for 2.6.12 (none debug)
STB04500 TDGFX 1.40 - Built Oct 28 2005/14:57:35 for 2.6.12 (none debug)
STB04500 TDOSS 1.28 - Built Oct 28 2005/14:57:20 for 2.6.12 (none debug)
Jan 1 00:00:34 tripledragon daemon.info init: starting pid 283, tty '': '/etc/init.d/start'
Please press Enter to activate this console. [neutrino] frameBuffer Instance created
libtriple debug options can be set by exporting TRIPLE_DEBUG.
The following values (or bitwise OR combinations) are valid:
component: audio 0x01
component: video 0x02
component: demux 0x04
component: play 0x08
component: power 0x10
component: init 0x20
component: ca 0x40
component: record 0x80
all components: 0xff
[LT:00000000:init ] init_td_api begin, initialized=0, debug=0x00
DFB input converter thread starting...
modprobe: module uinput not found in modules.dep
modprobe: module evdev not found in modules.dep
DFB input thread: unable to open /dev/misc/uinput (No such file or directory)
Where am I wrong?
Please give details about my mistake!
Thanks!