unable to get my dbox2 to enter debug mod.

[Craig_bitch]

i have been unable to get my dbox2 to enter debug mod.

I have tried and tried....

I entered the follow and it just flashes "reset" in the window..

icache
chorus 800000

then just says reset..

I have to reboot the box myself?

Any ideas?

[Anducha]

Are you shure you have a NOKIA Bmon ?!

Start you BOX, make flash reset and hold the Button UP .

Then there come a number like 01DD10081 161608.
If you not have on the fifth and sixth place the ten, you have to make the DebugMode in a different way.

[Craig_bitch]

many thanks for a reply

mine reads: 017a10081320008

tried also

setenv product?0
go 100000100

but this will not make it enter debug mode!!!

[mash4077]

mine reads: 017a10081320008

Hi,

take a look at this manual:

http://www.dietmar-h.net/mhc_debug_en.html

but this will not make it enter debug mode!!!

Right, because you have to use this method for example (if your box has 2xIntel):

http://www.dietmar-h.net/without_sh.html

regards
mash

[Craig_bitch]

thanks for the links, but i have been reading these already

I'll read them all again, but i've tried and everything the links explain

I have Nokia with 2xintel chips..
i've put jumpers on xh4 and xh6.
i've put wire to pin 12 of intel chip and put it to earth when booting.

and the
icache
so either my box is playing up or im missing something

[mash4077]

Hi,

taken from:

http://www.dietmar-h.net/mhc_debug_en.html

Most important is the version of the Bmon. If you happen to own a Nokia with 2 Intel flash chips and Bmon 1.0, this method is not going to work

regards
mash

[Craig_bitch]

I have tried the Nokia 2 intel-chip ONLY version...

http://www.dietmar-h.net/mhc_debugn2xi.html


It will still not go into debug????

I've everything within the above site.....

[Craig_bitch]

I know my software and leads work as i got another dbox with Neutreno already installed and i have been testing other images on it...

But the dbox2 that wont go in to debug mode is the same as my other 1..

Just can not think as to why it wont....

[mash4077]

Hi,

does the problem still exist?

regards
mash