Watchdog reset, warum?

[the]

Dbox2, Kabel, Nokia, 2xi bootet in Schleife. Ich sehe die Ursache nicht. Kann da jemand helfen, BITTE

Boot-log von Image alexW1xBaseimageV1.5.img:

=debug: DDF: Calibrating delay loop... debug: DDF: 67.79 BogoMIPS
debug: BMon V1.0 mID 01
debug: feID 7a gtxID 0b
debug: fpID 5a dsID 01-4f.00.05.07.00.00-97
debug: HWrev X5 SWrev 0.81
debug: B/Ex/Fl(MB) 32/00/08
WATCHDOG reset enabled
dbox2:root> debug:
BOOTP/TFTP bootstrap loader (v0.3)
debug:
debug: Transmitting BOOTP request via broadcast
debug: Given up BOOTP/TFTP boot
boot net failed

Flash-FS bootstrap loader (v1.5)

Found Flash-FS superblock version 3.1
File /root/platform/nokia-dbox2/kernel/os not found: No such file or directory
boot flash /root/platform/nokia-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Found Flash-FS superblock version 3.1
File /root/platform/mpc8xx-dbox2/kernel/os not found: No such file or directory
boot flash /root/platform/mpc8xx-dbox2/kernel/os failed

Flash-FS bootstrap loader (v1.5)

Found Flash-FS superblock version 3.1
Found file /root/platform/kernel/os in Flash-FS
debug: Got Block #0196

will verify ELF image, start= 0x800000, size= 202876
verify sig: 262
Branching to 0x40000


ppcboot 0.6.4 (Mar 2 2002 - 20:44:32)

Initializing...
CPU: PPC823ZTnnA at 67 MHz: 2 kB I-Cache 1 kB D-Cache
*** Warning: CPU Core has Silicon Bugs -- Check the Errata ***
Board: ### No HW ID - assuming TQM8xxL
DRAM: (faked) 32 MB
Ethernet: 00-50-9c-14-e4-3c
FLASH: 8 MB
LCD driver (KS0713) initialized
LCD logo at: 0x8F049 (0x1E00 bytes)
FB logo at: 0x90E71 (0x31C1 bytes)
AVIA Frambuffer
Input: serial
Output: serial


1: Console on null
2: Console on ttyS0
3: Console on framebuffer
Select (1-3), other keys to stop autoboot: 0
...............................................................
Un-Protected 63 sectors
Kernel image at: 0x10020034 (0x8EFED bytes)
## Booting Linux kernel at 10020034 ...
Image Name: dbox2
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 585645 Bytes = 571 kB = 0 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Linux version 2.4.19-pre8-dbox2 (von alexW) (gcc version 3.0.4) #16 Son Mai 19 1
9:32:22 UTC 2002
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: ro root=1f03 console=ttyS0
WARNING: Frequency is not in HZ. Please consider using a newer bootloader!
WARNING: OLD intfreq = 67 busfreq = 67
WARNING: NEW intfreq = 67000000 busfreq = 67000000
Decrementer Frequency = 251250000/60
mpc8xx-wdt: active wdt found (SWTC: 0xFFFF, SWP: 0x1)
mpc8xx-wdt: keep-alive trigger activated (PITC: 0x2000)
Console: colour dummy device 80x25
Calibrating delay loop... 66.56 BogoMIPS
Memory: 30920k available (1032k kernel code, 352k data, 64k init, 0k highmem)
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12 (20020219) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.1. (C) 2001, 2002 Red Hat, Inc., designed by Axis Communications
AB.
i2c-core.o: i2c core module
CPM UART driver version 0.03
ttyS00 at 0x0280 is a SMC
ttyS01 at 0x0380 is a SMC
pty: 256 Unix98 ptys configured
eth0: CPM ENET Version 0.2 on SCC2, 00:50:9c:14:e4:3c
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
D-Box 2 flash driver (size->0x800000 mem->0x10000000)
Using word write method
Creating 7 MTD partitions on "D-Box 2 flash memory":
0x00000000-0x00020000 : "BR bootloader"
0x00020000-0x000c0000 : "idxfs (kernel, logos)"
0x000c0000-0x00160000 : "var (jffs2)"
0x00160000-0x00760000 : "root (cramfs)"
0x00760000-0x00800000 : "flfs (ppcboot)"
0x00020000-0x00800000 : "flash without bootloader"
0x00000000-0x00800000 : "complete flash"
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (cramfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 64k init
init started: BusyBox v0.61.pre (2002.04.02-22:55+0000) multi-ca[i2c-8xx]: mpc
8xx i2c init
i2c-core.o: adapter registered as adapter 0.
[i2c-8xx]: adapter: 0
i2c-core.o: driver FOR_PROBE_ONLY registered.
i2c-core.o: driver unregistered: FOR_PROBE_ONLY
event: init ...
i2c-core.o: driver i2c audio/video switch driver registered.
i2c-core.o: client [CXA2092] registered to adapter [](pos. 0).
i2c-core.o: driver i2c saa7126 driver registered.
i2c-core.o: client [i2c saa7126 chip] registered to adapter [](pos. 1).
i2c-core.o: driver DBox2 Frontprocessor driver registered.
i2c-core.o: client [DBox2 Frontprocessor client] registered to adapter [](pos. 2
).
AVIA: $Id: avia_core.c,v 1.30 2002/05/06 02:18:18 obi Exp $
lcd.o: init lcd driver module
lcd.o: found KS0713/SED153X lcd interface on 1
der moment ist gekommen...
i2c-core.o: driver DBox2-CAM registered.
CAM: attaching CAM at 0x6e
i2c-core.o: client [DBOX2-CAM] registered to adapter [](pos. 3).
write 1 event's ...
write 1 event's ...
CAM: attached to adapter
[FONT] initializing core...
[FONT] adding font /share/fonts/micron_bold.ttf...OK (Micron/Bold)
[FONT] Intializing font cache...
[FONT] FTC_Face_Requester (Micron/Bold)
avia_gt_core: $Id: avia_gt_core.c,v 1.19 2002/05/09 19:54:19 obi Exp $
avia_gt_core: autodetecting chip type... AViA GTX found
avia_gt_gtx: $Id: avia_gt_gtx.c,v 1.13 2002/05/09 22:25:23 obi Exp $
avia_gt_dmx: $Id: avia_gt_dmx.c,v 1.86 2002/05/09 07:29:21 waldi Exp $
avia_gt_core: masking unhandled irq reg 1 bit 11
avia_gt_core: masking unhandled irq reg 1 bit 13
avia_gt_gv: $Id: avia_gt_gv.c,v 1.17 2002/05/09 22:23:30 obi Exp $
avia_gt_core: masking unhandled irq reg 0 bit 6
avia_gt_gv: set_input_size (width=720, height=576)
avia_gt_pcm: $Id: avia_gt_pcm.c,v 1.12 2002/05/08 12:56:41 obi Exp $
avia_gt_capture: $Id: avia_gt_capture.c,v 1.18 2002/05/01 21:51:35 Jolt Exp $
avia_gt_pig: $Id: avia_gt_pig.c,v 1.18 2002/05/07 16:59:19 Jolt Exp $
avia_gt_ir: $Id: avia_gt_ir.c,v 1.15 2002/05/13 22:38:36 Jolt Exp $
avia_gt_core: Loaded AViA eNX/GTX driver
Init VES1820
i2c-core.o: driver VES1820 DVB demodulator registered.
attach_adapter
VES1820: attaching VES1820 at 0x10
i2c-core.o: client [VES1820] registered to adapter [](pos. 4).
VES1820: attached to adapter
avia_gt_napi: $Id: avia_gt_napi.c,v 1.88 2002/05/07 16:59:19 Jolt Exp $
avia_gt_napi: warning, misaligned queue 0 (is 32a00, size 10000), aligning...
avia_gt_vbi: $Id: avia_gt_vbi.c,v 1.10 2002/05/06 02:18:18 obi Exp $
avia_gt_vbi: got demux C-Cube - AViA eNX/GTX
avia_gt_fb: $Id: avia_gt_fb_core.c,v 1.30 2002/05/03 16:47:35 obi Exp $
avia_gt_gv: set_input_mode (mode=3)
avia_gt_gv: set_input_size (width=720, height=576)
avia_gt_gv: set_input_mode (mode=3)
avia_gt_gv: set_input_size (width=720, height=576)
avia_gt_gv: set_input_mode (mode=3)
avia_gt_gv: set_input_size (width=720, height=576)
Console: switching to colour frame buffer device 90x36
avia_gt_fb: fb0: AViA eNX/GTX Framebuffer frame buffer device
CXA2092 found
CXA2092 found
Network LCD-Driver $Id: lcdd.cpp,v 1.48 2002/05/15 23:32:12 McClean Exp $

[lcdd] load config
/var/tuxbox/config/lcdd.conf: No such file or directory
[FONT] initializing core...
[FONT] adding font /share/fonts/micron.ttf...OK (Micron/Regular)
[FONT] Intializing font cache...
[FONT] FTC_Face_Requester (Micron/Regular)
$Id: sectionsd.cpp,v 1.126 2002/05/15 10:00:55 dirch Exp $
caching 504 hours
events are old 60min after their end time
dmxdev: set buffer size 40000 -> 60000
$Id: zapit.cpp,v 1.171 2002/05/04 15:25:25 McClean Exp $

/var/tuxbox/config/zapit/zapit.conf: No such file or directory
[getservices.cpp] /var/tuxbox/config/zapit/services.xml: No such file or directo
ry
[zapit] /var/tuxbox/config/zapit/bouquets.xml: No such file or directory
[zapit] channels have been loaded succesfully
Controld $Id: controld.cpp,v 1.58 2002/05/08 16:21:43 McClean Exp $

[controld] error while loading settings: /var/tuxbox/config/controld.conf
[controld] using defaults
[controld] Boxtype detected: (01, 1, 1, Nokia)
set event: 00000009
dmxdev: set buffer size 40000 -> 60000
debug: DDF: Calibrating delay loop... debug: DDF: 67.79 BogoMIPS
debug: WATCHDOG RESET

... und es beginnt von