Ich entschuldige mich um dieses Post, aber ich scpreche Deutsch nicht so gut wie English und so ich schreibe dieses Post in English.
I have Diseqc problem with Neutrino. I have Diseqc 2.0 switch 4/1, in input 1 (opt A/pos A) I have Astra 19.2° LNB plugged in, in 2 (opt A/pos B) Hotbird 13°.
Now in Diseqc I set Diseqc 1.0, and now what do I do in Diseqc-settings, I tried setting number 1 for astra and number 2 for hotbird but when I try to scan, on hotbird it just tries a few frequencies and then moves to astra, it doesn't even shows the number of transponders for hotbird, when it switches to astra it starts with some frequency and then and then it says that there are 65 transponders and begins with scan. Why it doesn't work with hotbird? Do I have to manualy add transponders? But I didn't add them for astra. Have I set it wrong in Diseqc-settings?
Image on dbox (philips dbox2) is yadi from http://dboxupdate.berlios.de dated 2.10.2004. I'm new to this, I flashed it for the first time today (yesterday actualy
) Sat. dish is OK, when I connect PC with SkyStar2 card to the same cable hotbird works normaly.If you have any link where diseqc setup in Neutrino is explained I'd be thankfull, it can be in german, I have no problems with reading and understanding it, just speaking, since I hear a lot of german, especialy when my relatives from Germany come to visit
, that's how I got dbox in the first place.