If I apply the sky mod patch the patch works fine but I get a black screen with the audio quite often , if I put in a neutrino file that is not patched then I never get this problem.
I notice it most on channel 4 (uk) but it can happen on any fta channel.
I have tested on a 1X sagem 2X sagem and my sons nokia and the same problem on each one.
I am new to this but looking at the patch there is nothing that should do this.
The image is a clean one, with just bouquet/services and ucodes/avia drivers
an unpatched one gives picture everytime but the patched one is hit and miss, I always get the audio stream.
I monitor in hyperterminal what is going on but there are no errors put up.
any pointers would be helpful.
sky mode patch problem
-
- Neugieriger
- Beiträge: 10
- Registriert: Mittwoch 19. April 2006, 11:28
-
- Developer
- Beiträge: 1475
- Registriert: Dienstag 4. Februar 2003, 22:02
-
- Neugieriger
- Beiträge: 10
- Registriert: Mittwoch 19. April 2006, 11:28
I used your patch, Before I ran the patch I compiled an image then I run the patch with no errors and compiled, If I use the unmodified image no black screens, if I run the patched image I get the black screens with audio stream only.
I have tested this on a 1x sagem, 2x sagem and a nokia box (all cable)
When I get a chance I will test it on my sat box and see if that is the same.
If I go up a channel then down a channel the picture comes back 90% of the time, with the unpatched image the picture is available 100% of the time.
I have tested this on a 1x sagem, 2x sagem and a nokia box (all cable)
When I get a chance I will test it on my sat box and see if that is the same.
If I go up a channel then down a channel the picture comes back 90% of the time, with the unpatched image the picture is available 100% of the time.
.
Have Fun
.
Have Fun
.
-
- Developer
- Beiträge: 1475
- Registriert: Dienstag 4. Februar 2003, 22:02
-
- Neugieriger
- Beiträge: 10
- Registriert: Mittwoch 19. April 2006, 11:28
I have found that using ucode_001A can eliminate the problem,
It has also been mentioned about other images tweaked for the uk cable system and only manifests on free to air channels.
Without the patch my 2x sagem works fine with 0014
I cannot use ucode_001A on my sagem 2x box so will have to accept the problem is with my box not accepting 001A.
Using 001A on the 1x and the nokia solves this isssue.
Thank you for looking at this probem.
It has also been mentioned about other images tweaked for the uk cable system and only manifests on free to air channels.
Without the patch my 2x sagem works fine with 0014
I cannot use ucode_001A on my sagem 2x box so will have to accept the problem is with my box not accepting 001A.
Using 001A on the 1x and the nokia solves this isssue.
Thank you for looking at this probem.
-
- Developer
- Beiträge: 1475
- Registriert: Dienstag 4. Februar 2003, 22:02